http://www.tracopower.com dc/dc converters THI 2 series, 2 watt features dipC24 plastic package i/o isolation voltage 2500 vacrms supplementary insulation rated for working voltage up to 250 vac regulated output operating temp. range C40c to +85c low coupling capacity short circuit protection 3-years product warranty order code input voltage range output voltage output current max. effciency typ. THI 0511 5 vdc 400 ma 62 % THI 0512 12 vdc 165 ma 63 % THI 0513 5.0 vdc 10% 15 vdc 130 ma 64 % THI 0520 5 vdc 100 ma 42 % THI 0521 12 vdc 80 ma 57 % THI 0522 15 vdc 65 ma 57 % THI 1211 5 vdc 400 ma 62 % THI 1212 12 vdc 165 ma 63 % THI 1213 12.0 vdc 10% 15 vdc 130 ma 64 % THI 1220 5 vdc 100 ma 45 % THI 1221 12 vdc 80 ma 59 % THI 1222 15 vdc 65 ma 59 % THI 2411 5 vdc 400 ma 62 % THI 2412 12 vdc 165 ma 63 % THI 2413 24 vdc 10% 15 vdc 130 ma 64 % THI 2420 5 vdc 100 ma 45 % THI 2421 12 vdc 80 ma 58 % THI 2422 15 vdc 65 ma 58 % models the THI 2 series is a family of dc/dc converter with very high i/o isolation specifca - tion. they are certifed according to en 60950 and iec 60601-1 safety standards and offer a cost effective solution for all industrial, telecom and medical applications where a supplementary insulation is required. smd technology and a 100 % pro - duction test of the safety barrier ensure a very high reliability of THIs product. page 1 of 3
http://www.tracopower.com dc/dc converters THI 2 series 2 watt input specifications input current no load / full load 5 vin models: 100 ma / 660 ma typ. 12 vin models: 50 ma / 280 ma typ. 24 vin models: 30 ma / 140 ma typ. surge voltage (1 sec. max.) 5 vin models: 7.5 v max. 12 vin models: 15 v max. 24 vin models: 30 v max. input filter pi-filter output specifications voltage set accuracy 3 % voltage balance (dual output models) 3 % max. regulation C input variation 0.5 % C load variation 10C100% 1.0 % max. ripple and noise (20 mhz bandwidth) 50 mvpk-pk max. temperature coefficient 0.02 %/k current limitation >120 % constant current short circuit protection continuous (automatic recovery) capacitive load single output models: 680 f max. dual output models: 270 f max. (each output) general specifications temperature ranges C operating C40c to +85c C case +95c max. C storage C40c to +125c derating 3 %/k above 70c humidity (non condensing) 95 % rel. h max. reliability, calculated mtbf (mil-hdbk-217f, at 25c, ground benign) >600000 h isolation voltage C i/o isolation voltage 2500 vacrms (rated for 250vac) C isolation test voltage (1 sec.) 6000 vpk isolation capacitance C input/output 20 pf typ. isolation resistance C input/output >10 gohm safety standards iec/en 60950 iec/en 60601-1, rated for 250vac switching frequency 25 C 80 khz (pfm) all specifcations valid at nominal input voltage, full load and +25c after warm-up time unless otherwise stated. page 2 of 3
r e v. 11/11 specifcations can be changed any time without notice. page 3 of 3 general specifications casing material plastic (ul 94v-0 rated) weight 12.4 g (0.44 oz) soldering temperature max. 265c / 10 sec dc/dc converters THI 2 series 2 watt outline dimensions 10 11 12 24 23 1 2 15 13 bottom view 20 15.24 2.4 (0.6) (0.79) (0.1) 10 4 (0.16) 27.94 2.0 32 2.54 2.54 20.32 2.54 (1.25) (1.1) (0.8) (0.08) (0.1) (0.1) (0.1) (0.4) pin single dual 1 +vin (vcc) +vin (vcc) 2 +vin (vcc) +vin (vcc) 10 no pin common 11 no pin common 12 Cvout no pin. 13 +vout Cvout 15 no pin +vout 23 Cvin (gnd) Cvin (gnd) 24 Cvin (gnd) Cvin (gnd) pin-out dimensions in [mm], () = inch pin diameter: 0.5 0.05 (0.024 0.002) tolerances: 0.25 (0.01) pin pitch tolerances: 0.05 (0.002) jenatschstrasse 1 ch-8002 zurich switzerland t el. +41 43 311 45 11 fax +41 43 311 45 45 info@traco.ch www .tracopower .com
|
